License File Of Cm; Ip License-Server - Avaya G450 Cli Reference Manual

Output fields
Name
Interface
Active
Slots
Packets Sent
Bytes Saved
Improvement
Factor
Related Commands
clear ip rtp header-compression,
compression-connections,
non-tcp-mode,
header-compression,

License file of CM

ip license-server

Use the ip license-server command to enable the media gateway to supply a hardware
serial number on behalf of an S8500 local survivable processor (LSP). The serial number is
required when an S8500 LSP registers with its primary controller (S8400 or S8500 Server)
using the Processor Ethernet interface.
The serial number might also be required if the S8500 is a primary controller, but is using
Processor Ethernet exclusively with H.248 media gateways. In this case, the S8500 does not
have an IPSI-controlled gateway to use for its hardware license verification.
Note:
There must be at least one H.248 media gateway (G700, G250, G350, G450, or
Note:
IG550) for each LSP in the main server's network. Only one LSP or primary
controller can use the serial number of a media gateway for license verification.
Description
The interface on which TCP header compressions is being applied
Whether TCP header compression is active and working on this
interface
The number of Rx and Tx slots. That is, the total number of TCP
header compression connections supported on this interface.
The number of compressed packets sent + the number of full
headers sent
The total saving in bytes due to compression
The efficiency of the compression, calculated as (bytes saved +
bytes sent)/ bytes sent (rounded to two decimal places)
clear ip tcp
ip rtp header-compression,
ip rtp port-range, ip tcp
show ip rtp header-compression
header-compression,
ip rtp
compression-connections,
brief,
License file of CM
ip rtp
max-period, ip rtp max-time,
show ip rtp
show ip tcp header-compression
Issue 1 January 2008
ip rtp
517