Set Port Edge Admin State - Avaya G450 Cli Reference Manual

Context
general
Example
To set port 6/5 to full duplex:
G450-001(super)# set port duplex 6/5 full
Port 6/5 set to full-duplex.
Related Commands
set port auto-negotiation-flowcontrol-advertisement,
disable, set port
point-to-point admin
auto-negotiation-flowcontrol-advertisement,

set port edge admin state

Use the set port edge admin state command to assign or de-assign RSTP edge-port
admin state to a port for Rapid Spanning Tree Protocol (RSTP) treatment.
Syntax
set port edge admin state module/port admin_state
Parameters
Parameter
module
port
admin_state
User Level
read-write
Context
general
flowcontrol, set port level,
status, set port speed,
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 10/5-6 for
both ETH LAN ports 5-6 on the front panel.
The type of the specified port
set port edge admin
set port name, set port
show port
show port edge state,
Ethernet port configuration
state, set port enable |
negotiation, set port
show port flowcontrol
Possible Default
Values Value
edge-port,
non-edge-port
Issue 1 January 2008 377