Udp Source-Port - Avaya G450 Cli Reference Manual

udp source-port

Use the udp source-port command to define a source port with the UDP protocol for which
to apply the current rule.
Use the no form of the command to set the UDP source port to
the protocol is set to UDP and the destination port is set to its default value.
Use the not form of the command to specify that the rule applies to all UDP ports other than the
requested ports. If the protocol is not UDP, the protocol is set to UDP and the destination port is
set to its default value
Note:
Issuing this command also sets the protocol to be UDP, if it is not already.
Note:
Syntax
[not] udp source-port any | {{eq | lt | gt} {port_name | port_number}}
| {range start_port end_port}
no udp source-port
Parameters
Parameter
any
eq
lt
gt
port_name
port_number
Description
Keyword that specifies to apply the
rule to a port with any name or
number
Keyword that specifies to apply the
rule to a port whose name or
number matches exactly to the
specified name or number
Keyword that specifies to apply the
rule to a port whose name or
number is less than the specified
name or number
Keyword that specifies to apply the
rule to a port whose name or
number is greater than the
specified name or number
The name of the port for which to
apply the rule
The number of the port for which
to apply the rule
Policy - access control lists
. If the protocol is not UDP,
any
Possible Values Default
Value
Issue 1 January 2008 703