Linecode (T1) - Avaya G450 Cli Reference Manual

CLI Commands

linecode (T1)

Use the linecode command to specify the type of line-code transmission for the a T1 line. Use
the no form of the command to restore the default line-code value of b8zs.
Note:
Normally the T1 service provider determines which type of line-code is required
Note:
for your T1 circuit.
Syntax
linecode {ami|b8zs}
Parameters
Parameter
ami
b8zs
User Level
read-write
Context
interface:Controller (T1)
Example
To set the line-code type to ami:
G450-001(super-controller:5/1)# linecode ami
Related Commands
clear controller
source, ds-mode, fdl, framing,
show controllers,
366 Avaya G450 CLI Reference
Description
Keyword that specifies the Alternate Mode
Inversion line-code type
Keyword that specifies the B8ZS line-code
type
counters, controller, cablelength
interface
show controllers remote,
long, cablelength
serial, ip address, linecode
show ds-mode
E1/T1 interfaces
Possible Default
Values Value
short, channel-group,
(E1), loopback, remote,
clock