Remove Nfas-Interface - Avaya G450 Cli Reference Manual

CLI Commands
Context
sls > sig-group
Example
To identify a list of DS1 modules that are controlled by the primary D-channel for gateway 005,
module v5, and DS1 circuit number 0:
G450-001(sls-sig-group 100)# add nfas-interface 005v5 0
Related Commands
clear sig-group,
set trunk-group-chan-select,

remove nfas-interface

Use the remove nfas-interface command to remove a member from a NFAS-managed
DS1 group in SLS. This command removes the
administration.
Note:
This command applies only to ISDN-PRI trunks in a NFAS-managed group.
Note:
Note:
This command is not valid unless the slot configuration has already been
Note:
administered (see
set to no (NFAS).
Syntax
remove nfas-interface gateway module
Parameters
Parameter
gateway
module
User Level
read-write
1014 Avaya G450 CLI Reference
remove nfas-interface,
show (sig-group),
set slot-config) and the
Description
3-digit gateway number (for example, 005)
2-character slot number (for example, v4). This
number identifies a port on an already-provisioned
DS1 board module (see
set associated-signaling,
show sig-group,
add nfas-interface
set associated-signaling
add port).
SLS survivability
set primary-dchannel,
show sls, sig-group, sls
gateway and module
command is
Possible
Values
set sls,
Default
Value