Udp Destination-Port - Avaya G450 Cli Reference Manual

udp destination-port

Use the udp destination-port command to define a destination port with the UDP protocol
for which to apply the current rule.
Use the no form of the command to set the UDP destination port to
UDP, the protocol is set to UDP and the source port is set to its default value.
Use the not form of the command to specify that the rule applies to all UDP ports other than the
requested ports. If the protocol is not UDP, the protocol is set to UDP and the source port is set
to its default value
Note:
Issuing this command also sets the protocol to be UDP, if it is not already.
Note:
Syntax
[not] udp destination-port any | {{eq | lt | gt}
{port_name | port_number}} | {range start_port end_port}
no udp destination-port
Parameters
Parameter
any
eq
lt
gt
port_name
port_number
range
Description
Keyword that specifies to apply the rule to a
port with any name or number
Keyword that specifies to apply the rule to a
port whose name or number matches exactly to
the specified name or number
Keyword that specifies to apply the rule to a
port whose name or number is less than the
specified name or number
Keyword that specifies to apply the rule to a
port whose name or number is greater than the
specified name or number
The name of the port for which to apply the rule
The number of the port for which to apply the
rule
Keyword indicating that a range of ports is
specified
Policy - access control lists
. If the protocol is not
any
Possible Default
Values Value
Issue 1 January 2008 701