Show Voip-Parameters - Avaya G450 Cli Reference Manual

CLI Commands

show voip-parameters

Use the show voip-parameters command to display information about the current VoIP
engine.
Syntax
show voip-parameters
User Level
read-only
Context
general
Examples
To display VoIP information:
G450-001(super)# show voip-parameters
VOIP ENGINE PARAMETERS
---------------------------------------------------------
IP (PMI)
DSP Firmware Version
Fault Status
Additional Status
CURRENT STATE
---------------------------------------------------------
In Use : 20 of
VoIP -DSPs PARAMETERS
VoIP Child
Slot Board
---- -----
1 VOIP
2 VOIP
3 -- Not Installed --
4 SYNC
Related Commands - VoIP
busyout voip-dsp,
test voip-dsp
Related Commands - QoS
set qos bearer,
1200 Avaya G450 CLI Reference
: 149.49.78.140
: N/A
: No Fault Messages
: No Status Messages
100 channels, 240of 1200 points (0.0% used)
CODE SUFFIX HW
VINTAGE
---- ------ -------
8122 A 3
7119 A 5
campon-busyout voip-dsp,
set qos control, set qos
FW Chan
VINTAGE InUse
-------- -------
235 20/80
215 0/20
release voip-dsp,
signal, show ip qos-list
VoIP testing
Admin Oper
State State
----- -----
Release InUse
Busyout Idle
reset voip-dsp, show voip-dsp,
Fault
Status
------
No Error
No Error