Show Port Mirror - Avaya G450 Cli Reference Manual

CLI Commands
Parameters
Parameter
module
port
sampling_
value
direction_
value
User Level
read-write
Context
general
Example
To set up port mirroring from port 10/5 to port 10/6 in the G450 for all packets sent and received:
G450-001(super)# set port mirror source-port 10/5 mirror-port 10/6 sampling
always direction both
Related Commands
clear port mirror,

show port mirror

Use the show port mirror command to display mirroring information for the specified port.
If no port is specified, information for all ports is displayed.
Syntax
show port mirror [module/port]
802 Avaya G450 CLI Reference
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 10/5-6 for
ETH LAN ports 5-6 on the front panel.
Specifies whether to allow or disable
sampling of the transmissions
The direction of transmissions to mirror
show port mirror
Port mirroring
Possible Default
Values Value
always,
disable
rx, tx,
both