Show (Ds1) - Avaya G450 Cli Reference Manual

CLI Commands
Parameters
Parameter
mode-type
User Level
read-write
Context
sls > ds1
Example
To set the signaling mode for the DS1 facility to PRI:
G450-001 (sls-ds1-<port address>)# set signaling-mode isdnpri
Related Commands
clear ds1, set
country-protocol,
protocol-version,

show (ds1)

Use the show command to list the administered DS1 parameters for SLS for this trunk interface.
Syntax
show
978 Avaya G450 CLI Reference
Description
The signaling mode for the DS1 facility.
cas – Out-of-band signaling for E1 service,
●
yielding thirty 64kbps B-channels for voice
transmission
robbedbit – In-band signaling for T1 service,
●
yielding twenty-four 56kbps B-channels for
voice transmission
idsnpri – Use this setting for either T1 or E1
●
ISDN Primary Rate service (supports both FAS
and NFAS)
isdnext – NFAS T1 or E1 ISDN service for:
●
- T1 facility in which all 24 channels are for
bearer transport
- E1 facility in which all 31 channels are for
bearer transport
bearer-capability, set
set interface, set interface-companding,
set side, set sls, show
bit-rate, set channel-numbering,
(ds1), show ds1,
SLS survivability
Possible
Values
cas
robbedbit
idsnpri
isdnext
set connect,
set long-timer, set name,
show sls, sls
Default
Value
idsnpri
set
set