Channel-Group - Avaya G450 Cli Reference Manual

channel-group

Use the channel-group command to create a channel group logical interface for a PPP or
Frame Relay session. Use the no form of the command to delete a channel group.
Note:
If you issue this command with an existing channel number, the timeslots you
Note:
specify will replace any that already exist.
Syntax
channel-group channel_number timeslots ts_list speed speed_value
no channel-group channel_number
Parameters
Parameter
channel_
number
ts_list
speed_value
User Level
read-write
Context
interface:Controller
Example
To create a new channel group number 2, with time slots 5, 6, and 8 and speed of 56:
G450-001(super-controller:5/1)# channel-group 2 timeslots 5-6,8 speed 56
Related Commands
clear controller
fdl, framing, interface
controllers, show controllers
Description
The ID number to identify the channel
group
The time slots to include in this channel
group. Values can be separated either by
a "–" for a range, or by commas for a list.
The acceptable speed values
counters, controller, cablelength
serial, ip address,
remote,
long, cablelength
linecode (E1), linecode
show ds-mode
E1/T1 interfaces
Possible Default
Values Value
For T1: 0-23
For E1: 0-30
For T1: 1-24
For E1: 1-31
56, 64 56
short, clock source, ds-mode,
(T1), loopback, remote,
Issue 1 January 2008
show
361