Set Swhook-Flash - Avaya G450 Cli Reference Manual

Example
To set virtual integrated port v305 to a given station:
G450-001 (sls-station-<extension>)# set port v305
Related Commands
set cor, set expansion-module,
trunk-destination,

set swhook-flash

Use the set swhook-flash command to enable SLS to recognize the switchhook flash
signal from a particular analog station and to provide subsequent transfer service.
Note:
This command is valid only when the station type is analog2500.
Note:
Syntax
set swhook-flash {yes | no}
Parameters
Parameter
yes
no
User Level
read-write
Context
sls > station
set name,
set type (station), show
Description
Keyword indicating that SLS recognizes the
switchhook signal and transfers the call.
This is the default for analog phone only.
Keyword indicating that SLS does not
recognize the switchhook signal and
transfers the call. This is the default for IP
and DCP phones only.
set password, set sls,
(station), show sls, station,
SLS survivability
set swhook-flash, set
sls
Possible Default
Values Value
Issue 1 January 2008 1027