Set Japan-Disconnect - Avaya G450 Cli Reference Manual

set japan-disconnect

Use the set japan-disconnect command to perform a disconnect sequence (CONNECT
message followed by a DISCONNECT message) in SLS.
Note:
This command only applies to ISDN trunks.
Note:
Syntax
set japan-disconnect {yes | no}
Parameters
Parameter
yes
no
User Level
read-write
Context
sls > trunk-group
Example
To choose not to perform a disconnect sequence:
G450-001 (sls-trunk-group-<tgnum>)# set japan-disconnect no
Related Commands
add port, clear
cbc-service-feature,
set digits, set digit-handling,
set name, set numbering-format,
trunk-hunt, set
Description
Keyword specifying to perform a
disconnect sequence
Keyword specifying not to perform a
disconnect sequence. This is the default.
tac, clear trunk-group,
set channel-preference,
set digit-treatment,
set
sls, show (trunk-group),
remove port, set cbc,
set codeset-display,
set incoming-destination,
send-name, set send-number,
show sls, show trunk-group
SLS survivability
Possible Default
Values Value
set cbc-parameter, set
set codeset-national,
set incoming-dialtone,
set supervision,
sls, trunk-group
Issue 1 January 2008
set dial,
set tac, set
1053