Set Port Negotiation - Avaya G450 Cli Reference Manual

Related Commands
set port auto-negotiation-flowcontrol-advertisement,
set port edge admin
negotiation, set port point-to-point admin
auto-negotiation-flowcontrol-advertisement,

set port negotiation

Use the set port negotiation command to enable or disable auto-negotiation on the
specified port. Auto-negotiation uses a link negotiation protocol to determine the highest
connection parameters available to connected ports, and configures the port speed and duplex
setting of both ports. This command applies to Fast Ethernet or Gigabit Ethernet ports.
If negotiation is disabled, the user can set the speed and duplex of the Fast Ethernet ports.
Syntax
set port negotiation module/port {enable|disable}
Parameters
Parameter
module
port
enable
disable
User Level
read-write
Context
general
state, set port enable |
status,
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 10/5-6 for
both ETH LAN ports 5-6 on the front panel.
Keyword specifying to enable port negotiation
protocol
Keyword specifying to disable port negotiation
protocol
set port enable |
disable, set port flowcontrol,
set port speed, show port
show port edge state,
Ethernet port configuration
disable, set port duplex,
set port level, set port
show port flowcontrol
Possible Default
Values Value
Issue 1 January 2008 383