Ip Ospf Authentication - Avaya G450 Cli Reference Manual

CLI Commands

ip ospf authentication

Use the ip ospf authentication command to specify the authentication type for an
interface. Use the no form of the command to remove the authentication type for an interface.
Syntax
ip ospf authentication auth_type
no ip ospf authentication
Parameters
Parameter
auth_type
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3, PPP L2-L3, PPP L3), VLAN (L2-L3,
L3), Loopback (L2-L3, L3), Tunnel (L2-L3, L3), Dialer (L2-L3, L3)
Example
To set the OSPF authentication for the FastEthernet interface as message-digest:
G450-001(if:FastEthernet 10/2)# ip ospf authentication message-digest
Related Commands
ip ospf authentication-key,
message-digest-key,
ospf, show ip ospf,
ip protocols
616 Avaya G450 CLI Reference
Description
The type of authentication
ip ospf cost, ip ospf
ip ospf network point-to-multipoint,
show ip ospf database,
dead-interval, ip ospf
ip ospf priority,
show ip ospf interface,
Possible Default
Values Value
message- null
digest,
null
hello-interval, ip ospf
ip ospf router-id,
show ip ospf neighbor,
OSPF
router
show