Add Nfas-Interface - Avaya G450 Cli Reference Manual

add nfas-interface

Use the add nfas-interface command to identify a list of DS1 modules that are controlled
by the primary D-channel in SLS.
Note:
This command applies only to ISDN-PRI trunks in a NFAS-managed group.
Note:
Note:
This command is not valid unless the slot configuration has already been
Note:
administered (see
set to no (NFAS).
Note:
The North American Public Network Service Providers do not allow any part of a
Note:
T1 to be shared outside of this NFAS-trunk group. In other words, they do not
allow one of the T1 interfaces (of this NFAS group) to be fractionalized into 2 or
more uses. It must be dedicated to this given customer. Therefore the following
usage rules apply:
- All members of an NFAS DS1 (that are administered) must belong to the same
trunk-group.
- All members of this trunk-group must belong to a single signaling group.
Syntax
add nfas-interface {gateway module [interface-id]}
Parameters
Parameter
gateway
module
interface-id
User Level
read-write
set slot-config) and the
Description
3-digit gateway number (for example, 005)
2-character slot number (for example, v4). This
number identifies a port on an already-provisioned
DS1 board module (see
The DS1 circuit number that is associated with the
NFAS group. This number must be coordinated
with the public network service provider so that the
signaling protocol operates correctly.
set associated-signaling
add port).
Issue 1 January 2008
SLS survivability
command is
Possible Default
Values Value
0-31
1013