Crypto Ipsec Nat-Transparency Udp-Encapsulation - Avaya G450 Cli Reference Manual

VPN
User Level
read-write
Context
interface:Serial (DS1 PPP L2, DS1 PPP L2-L3, DS1 FR-SUB L2, DS1 FR-SUB L2-L3,
USP PPP L2, USP PPP L2-L3), FastEthernet (L2, L2-L3, PPP L2, PPP L2-L3), VLAN (L2,
L2-L3), Dialer (L2, L2-L3)
Example
To set the minimal PMTU value to 128:
G450-001(if:Serial 4/1)# crypto ipsec minimal-pmtu 128
Related Commands
crypto ipsec df-bit, ip crypto-group

crypto ipsec nat-transparency udp-encapsulation

NAT Traversal is enabled in the device by default. Use the crypto ipsec
nat-transparency udp-encapsulation command to re-enable NAT Traversal if it was
disabled. Use the no form of the command to completely disable NAT Traversal in the device.
Syntax
[no] crypto nat-transparency udp-encapsulation
User Level
read-write
Context
general
Example
To re-enable NAT Traversal:
G450-001(super)# no crypto ipsec nat-transparency udp-encapsulation
Related Commands
crypto isakmp nat keepalive, ip crypto-group
Issue 1 January 2008 1207