Ip Rip Send-Receive-Mode - Avaya G450 Cli Reference Manual

CLI Commands
Parameters
Parameter
1
2
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3, PPP L2-L3, PPP L3), VLAN (L2-L3,
L3), Loopback (L2-L3, L3), Tunnel (L2-L3, L3), Dialer (L2-L3, L3)
Example
To specify that RIP version 2 packets should be running on the Serial 3/1:1 interface:
G450-001(if:Serial 3/1:1)# ip rip rip-version 2
Related Commands
ip distribution access-list,
default-route-mode,
rip, show ip protocols

ip rip send-receive-mode

Use the ip rip send-receive-mode command to set the RIP send and receive modes on
an interface. Use the no form of this command to set the RIP to talk (that is, send report).
Syntax
ip rip send-receive-mode mode [default_route_metric]
no ip rip send-receive-mode
862 Avaya G450 CLI Reference
Description
Keyword indicating that RIP version 1
packets should be used
Keyword indicating that RIP version 2
packets should be used
ip rip authentication
ip rip poison-reverse,
key, ip rip authentication
ip rip send-receive-mode,
Possible Default
Values Value
mode, ip rip
ip rip split-horizon, router
RIP