Ip Rip Default-Route-Mode - Avaya G450 Cli Reference Manual

CLI Commands
Related Commands
ip distribution access-list,
poison-reverse,
ip protocols

ip rip default-route-mode

Use the ip rip default-route-mode command to enable learning of the default route
received by the RIP protocol. Use the no form of this command to disable listening to default
routes.
Syntax
ip rip default-route-mode mode
no ip rip default-route-mode
Parameters
Parameter
mode
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3, PPP L2-L3, PPP L3), VLAN (L2-L3,
L3), Loopback (L2-L3, L3), Tunnel (L2-L3, L3), Dialer (L2-L3, L3)
Example
To specify that the RIP protocol sends, but does not receive, default route updates on the VLAN
1 interface:
G450-001(if:Vlan 1)# ip rip default-route-mode talk-only
860 Avaya G450 CLI Reference
ip rip authentication
ip rip rip-version, ip rip
Description
The default mode
key, ip rip default-route-mode,
send-receive-mode, ip rip
Possible Values
talk-listen — RIP sends and
receives default route updates
on the interface
talk-only — RIP sends, but
does not receive, default route
updates on the interface
ip rip
split-horizon, router rip,
Default
Value
talk-listen
RIP
show