Udp Source-Port - Avaya G450 Cli Reference Manual

To specify that rule 22 applies to all packets except for those whose destination port is 300:
G450-001(ACL 330/ip rule 22)# not udp destination-port eq 300
Related Commands - Policy-based routing
destination-ip, dscp (policy-based routing, packet sniffing,
capture-list, source-ip,
Related Commands - Policy
composite-operation, destination-ip,
dscp-table, show isdn bri

udp source-port

Related Commands - VPN
description (ip rule), destination-ip,
icmp, ip crypto-list, ip-protocol,
show ip crypto-list,
udp source-port
Use the udp source-port command to define a source port with the UDP protocol for which
to apply the current rule.
Use the no form of the command to set the UDP source port to
the protocol is set to UDP and the destination port is set to its default value.
Use the not form of the command to specify that the rule applies to all UDP ports other than the
requested ports. If the protocol is not UDP, the protocol is set to UDP and the destination port is
set to its default value
Note:
Issuing this command also sets the protocol to be UDP, if it is not already.
Note:
Syntax
udp source-port any | {{eq | lt | gt} {port_name | port_number}}
| {range start_port end_port}
no udp source-port
tcp destination-port,
dscp
link, source-ip,
dscp (policy-based routing, packet sniffing,
ip-rule (VPN), local-address,
tcp destination-port, tcp
VPN), icmp, ip-protocol,
tcp source-port, udp source-port
(policy), icmp, show
tcp destination-port, tcp
protect crypto
source-port, udp source-port
Packet sniffing
show ip
composite-operation,
established, tcp source-port,
VPN), fragment,
map, source-ip,
. If the protocol is not UDP,
any
Issue 1 January 2008
show
667