Local-Address - Avaya G450 Cli Reference Manual

CLI Commands
Example
To specify that rule 22 of QoS policy list 460 applies to any packet coming from IP address
135.64.104.102:
G450-001(QoS 460/rule 22)# source-ip host 135.64.104.102
Related Commands - Policy-based routing
destination-ip,
capture-list, tcp
Related Commands - Policy
composite-operation, destination-ip,
dscp-table, show isdn bri
destination-port,
Related Commands - VPN
description (ip
map, show ip crypto-list

local-address

Use the local-address command to set the local IP address for the IPSec tunnels derived
from the crypto-list. Use the no form of the command to delete the local IP address.
Note:
You must configure a local address before activating a list.
Note:
Note:
You cannot change or delete the local address of an active list.
Note:
Syntax
[no] local-address {ip-interface-address | ip-interface-name-id}
Parameters
Parameter
ip-interface-address
ip-interface-name-id
1248 Avaya G450 CLI Reference
dscp (policy-based routing, packet sniffing,
destination-port, tcp
link, tcp destination-port,
udp source-port
rule), destination-ip, ip
source-port, udp destination-port,
dscp (policy), icmp, show
tcp established,
crypto-list, ip-rule (VPN), local-address,
Description
The IP address of an IP
interface of the device
The name of an IP
interface of the device
VPN), icmp, ip-protocol,
udp source-port
composite-operation,
tcp source-port,
protect crypto
Possible Default
Values Value
VPN
show ip
show
udp