Interface Tunnel - Avaya G450 Cli Reference Manual

CLI Commands
Context
general, interface:serial (FR SUB)
Example
To create point to point sub-interface number 17 over channel group 2 over E1/T1 controller
number 1:
G450-001(super)# interface serial 3/1:2.17 point-to-point
Related Commands
description (interface),
tunnel, interface
ip crypto-group, load-interval,

interface tunnel

Use the interface tunnel command to enter Tunnel interface configuration mode. Use the
no form of this command to delete a Tunnel interface.
If the specified interface does not exist, the system creates it and enters its configuration mode.
Syntax
[no] interface tunnel tunnel_number
Parameters
Parameter
tunnel_number
User Level
read-write
Context
general
Example
To create interface tunnel 1 and enter its configuration mode:
G450-001(super)# interface tunnel 1
468 Avaya G450 CLI Reference
interface console,
USB-modem, interface
show ip interface brief
Description
The number of the interface
interface fastethernet,
vlan, ip address, ip admin-state,
IP interface configuration
interface loopback, interface
ip broadcast-address,
Possible Default
Values Value
1-99