Qos; Set Qos Bearer - Avaya G450 Cli Reference Manual

CLI Commands
Related Commands
arp, arp timeout,

QoS

set qos bearer

Use the set qos bearer command to permit the setting of VoIP QoS-bearer related
parameters for the Media Gateway Processor and VoIP engines. Since Media Gateway
Controller and VoIP engines share the same setup, local values are not set to entered values
unless set qos control local has been executed (refer to
Syntax
set qos bearer {bbedscp | efdscp | 802p | rtpmin | rtpmax} value
Parameters
Parameter
bbedscp
efdscp
802p
rtpmin
rtpmax
value
838 Avaya G450 CLI Reference
clear arp-cache, ip max-arp-entries,
Description
Keyword specifying that the following value is the
BBE differentiated services code point
Keyword specifying that the following value is the
EF differentiated services code point
Keyword specifying that the following value is the
802 priority value
Keyword specifying that the following value is the
RTP port min value. The rtpmin value must be an
even number, and the difference between rtpmin
and rtpmax must be at least 129.
Keyword specifying that the following value is the
RTP port max value. The rtpmax value must be an
odd number and the difference between rtpmax and
rtpmin must be at least 129.
A value for the specified keyword
show ip arp, show ip reverse-arp
set qos control
Possible
Values
0-63
0-63
0-7
2048-65406
2177-65535
QoS
on page 839).
Default
Value
43
46
6
2048
65535