Icmp - Avaya G450 Cli Reference Manual

Related Commands - Policy-based routing
dscp (policy-based routing, packet sniffing,
routing), show ip
Related Commands - Policy
composite-operation,
bri link, source-ip,
udp source-port, cos,
Related Commands - VPN
description (ip rule), destination-ip,
crypto-list, ip-protocol,
crypto-list, tcp destination-port,

icmp

Use the icmp command to specify that the current rule applies to a specific type of ICMP
packet.
Use the not form of this command to specify that the rule applies to all packets except those of
the requested ICMP attribute. If the IP protocol is not ICMP, it is set to ICMP.
Use the no form of the command to specify that the current rule applies to any type of ICMP
packet.
Note:
The icmp command also sets the IP protocol to ICMP.
Note:
Syntax
[not] icmp {name | {icmp_type icmp_code}}
no icmp
Parameters
Parameter
name
next-hop-list, show isdn bri link
dscp (policy), destination-ip, icmp,
tcp destination-port,
name
dscp (policy-based routing, packet sniffing,
ip-rule (VPN), local-address,
tcp source-port,
Description
Specify that the rule
applies to this ICMP name
VPN), destination-ip,
show
tcp established, tcp source-port,
protect crypto
udp destination-port,
Possible Values
Policy - access control lists
next-hop (policy-based
composite-operation,
udp destination-port,
VPN), icmp,
map, source-ip, show ip
udp source-port
Default
Value
Issue 1 January 2008
show isdn
ip
689