Set Incoming-Dialtone - Avaya G450 Cli Reference Manual

CLI Commands

set incoming-dialtone

Use the set incoming-dialtone command to provide a dial tone in response to far-end
trunk group seizures in SLS.
Note:
This command only applies to digital DS1 trunks set up for inband signaling.
Note:
Syntax
set incoming-dialtone {
Parameter
yes
no
User Level
read-write
Context
sls > trunk-group
Example
To withhold a dial tone:
G450-001 (sls-trunk-group-<tgnum>)# set incoming-dialtone no
Related Commands
add port, clear
cbc-service-feature,
set digits, set digit-handling,
set name, set
trunk-hunt, set
1052 Avaya G450 CLI Reference
yes | no}
Description
A keyword indicating to provide a dial tone
A keyword indicating trunks that are not
sending digits, for example, an incoming
call on a loop-start central office trunk.
This is the default value.
tac, clear trunk-group,
set channel-preference,
set digit-treatment,
numbering-format, set
sls, show (trunk-group),
remove port, set cbc,
set codeset-display,
set incoming-destination,
send-name, set send-number,
show sls, show trunk-group
SLS survivability
Possible Default
Values Value
set cbc-parameter, set
set codeset-national,
set japan-disconnect,
set supervision,
sls, trunk-group
set dial,
set tac, set