Set Numbering-Format - Avaya G450 Cli Reference Manual

Related Commands - Trunk-group commands
add port, clear
set codeset-national,
incoming-destination,
send-name, set
(trunk-group), trunk-group
Related Commands - DS1 commands
clear ds1, set bearer-capability,
country-protocol,
set side, set signaling-mode,
Related Commands - BRI commands
bri, clear bri, set
directory-number-b,
set side, set spid-a,
Related Commands - SLS commands
set sls, show sls,

set numbering-format

Use the set numbering-format command to specify the numbering plan for the current
trunk in SLS. The numbering plan encodes the Numbering Plan Indicator and Type of
Number fields in the Calling/Connected Party Number IE in the ISDN protocol.
Note:
Leave the setting of type to be unknown since SLS does not currently support
Note:
an administrative table to calculate the Calling Party Number that is consistent
with the numbering plan of the PSTN service provider.
Note:
This command only applies to ISDN trunks.
Note:
Syntax
set numbering-format type
tac, clear trunk-group,
set dial, set digits,
set incoming-dialtone,
send-number, set supervision,
set bit-rate,
set interface, set interface-companding,
show (ds1),
bearer-capability, set
set endpoint-init,
set spid-b, set tei-assignment,
sls
remove port, set channel-preference,
set digit-handling, set
set japan-disconnect,
set tac, set trunk-hunt,
set channel-numbering,
set
show ds1
country-protocol, set
set interface, set interface-companding,
show bri,
SLS survivability
set codeset-display,
digit-treatment, set
set numbering-format,
show trunk-group,
set connect,
long-timer, set protocol-version,
directory-number-a, set
set
show (bri)
Issue 1 January 2008
set
show
set
layer1-stable,
1055