Show Ip Interface - Avaya G450 Cli Reference Manual

Syntax
load-interval seconds
no load-interval
Parameters
Parameter
seconds
User Level
read-write
Context
Interface: Console, Serial (DS1 PPP L2, DS1 PPP L2-L3, DS1 FR L2, USP PPP L2,
USP PPP L2-L3, USP FR L2), FastEthernet (L2, L2-L3, PPP L2, PPP L2-L3), VLAN (L2,
L2-L3), Loopback (L2, L2-L3), Tunnel (L2, L2-L3), Dialer (L2, L2-L3), USB-modem
Example
To set the load calculation interval to 60 seconds:
G450-001(if:Serial 3/1:1)# load-interval 60
Related Commands
description (interface),
serial, interface
broadcast-address,

show ip interface

Use the show ip interface command to display information about an interface that has an
IP address or about all interfaces that have IP addresses.
Syntax
show ip interface [interface_name|ip_interface|ip_address]
Description
The load calculation interval, in seconds.
This parameter must be divisible by 30.
interface console,
tunnel, interface USB-modem,
show ip interface brief
interface fastethernet,
interface vlan, ip
IP interface configuration
Possible Default
Values Value
30-600 300
interface loopback, interface
address, ip admin-state,
Issue 1 January 2008
ip
475