Interface Usb-Modem - Avaya G450 Cli Reference Manual

Related Commands - IP interface configuration
description (interface),
serial, interface
load-interval, show ip interface brief
Related Commands - GRE tunneling
interface fastethernet,

interface USB-modem

Use the interface usb-modem command to enter the configuration context for the USB
interface. Use the no form of the command to reset the USB interface settings to their factory
defaults.
The USB interface always exists, but is disabled by default. Use the no shutdown command
to enable the interface.
The default settings for the USB-modem interface are:
Interface status
IP address
Netmask
timeout
PPP speed
Async
modem-init-string
Syntax
[no] interface usb-modem
User Level
read-write
Context
general
Example
To enter the USB-modem interface context:
G450-001(super)# interface usb-modem
G450-001(super-if:USB-modem)#
interface console,
USB-modem, interface
tunnel dscp, tunnel mode
DOWN
10.3.0.3
255.255.255.0
no timeout
38400 bps
"AT S7=45 S0=2 L1 V1 X4 &c1 E0
Q0"
interface fastethernet,
vlan, ip address, ip admin-state,
IP interface configuration
interface loopback, interface
ip broadcast-address,
Issue 1 January 2008 469