Show Port Lldp Config - Avaya G450 Cli Reference Manual

Example
To display the global LLDP configuration:
G450-001(super)# show lldp config
Lldp Configuration
-------------------
Application status: enable
Tx interval: 30 seconds
Tx hold multiplier: 4
Tx delay: 2 seconds
Reinit delay: 2 seconds
Output fields
Name
Application
status
Tx interval
Tx hold
multiplier
Tx delay
Reinit delay
Related Commands
set lldp re-init-delay,
tx-interval, set port
vlan-name config

show port lldp config

Use the show port lldp config command to display port-level LLDP configuration.
Syntax:
show port lldp config [module/port]
Description
Whether the LLDP application is enabled or disabled
The interval at which the device transmits LLDP frames
The value of the multiplier on the TxInterval that determines the
actual TTL value sent in an LLDP frame
The minimum delay between successive LLDP frame
transmissions
The delay in seconds from when a port is set to LLDP "disable",
until re-initialization is attempted
set lldp system-control,
lldp, set port lldp tlv, show
set lldp tx-delay, set lldp
lldp, show port lldp config,
tx-hold-multiplier, set lldp
show port lldp
Issue 1 January 2008
LLDP
541