Udp Destination-Port - Avaya G450 Cli Reference Manual

Related Commands - Policy-based routing
destination-ip, dscp (policy-based routing, packet sniffing,
capture-list, source-ip,
Related Commands - Policy
composite-operation, destination-ip,
dscp-table, show isdn bri
destination-port,
Related Commands - VPN
description (ip rule), destination-ip,
icmp, ip crypto-list, ip-protocol,
show ip crypto-list,

udp destination-port

Use the udp destination-port command to define a destination port with the UDP protocol
for which to apply the current rule.
Use the no form of the command to set the UDP destination port to
UDP, the protocol is set to UDP and the source port is set to its default value.
Use the not form of the command to specify that the rule applies to all UDP ports other than the
requested ports. If the protocol is not UDP, the protocol is set to UDP and the source port is set
to its default value
Note:
Issuing this command also sets the protocol to be UDP, if it is not already.
Note:
Syntax
udp destination-port any | {{eq | lt | gt}
{port_name | port_number}} | {range start_port end_port}
no udp destination-port
tcp destination-port,
dscp
link, source-ip,
udp source-port
dscp (policy-based routing, packet sniffing,
ip-rule (VPN), local-address,
tcp destination-port,
VPN), icmp, ip-protocol,
udp destination-port,
(policy), icmp, show
tcp destination-port, tcp
protect crypto
udp destination-port, udp source-port
Packet sniffing
show ip
udp source-port
composite-operation,
established, udp
VPN), fragment,
map, source-ip,
. If the protocol is not
any
Issue 1 January 2008
show
665