Ip Ospf Hello-Interval - Avaya G450 Cli Reference Manual

CLI Commands

ip ospf hello-interval

Use the ip ospf hello-interval command to specify the time interval between hello
packets the router sends. Use the no form of this command to set the hello-interval to its default
value.
Syntax
ip ospf hello-interval seconds
no ip ospf hello-interval
Parameters
Parameter
seconds
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3, PPP L2-L3, PPP L3), VLAN (L2-L3,
L3), Loopback (L2-L3, L3), Tunnel (L2-L3, L3), Dialer (L2-L3, L3)
Example
To specify an interval of 5 seconds between hello packets:
G450-001(if:Vlan 1)# ip ospf hello-interval 5
Related Commands
ip ospf authentication,
message-digest-key,
ospf, show ip ospf,
ip protocols
620 Avaya G450 CLI Reference
Description
The interval in seconds
ip ospf authentication-key,
ip ospf network point-to-multipoint,
show ip ospf database,
ip ospf cost, ip ospf
ip ospf priority,
show ip ospf interface,
Possible Default
Values Value
1-65535 10
dead-interval, ip ospf
ip ospf router-id,
show ip ospf neighbor,
OSPF
router
show