Interface Serial - Avaya G450 Cli Reference Manual

Related Commands
description (interface),
tunnel, interface
load-interval, show ip interface brief

interface serial

Use the interface serial command to enter Serial interface or sub interface configuration
mode. If the specified interface or sub interface does not exist, the system creates it and enters
its configuration mode.
Use the no form of the command to delete the interface. The no form can only be used to delete
sub L3 and sub frame relay interfaces. The command fails for USP interfaces and when higher
or lower layers are defined for that interface.
Syntax
[no] interface serial module/if_number [if_link_type]
For USP interfaces if_number has the syntax:
port[.ip_interface | {.sub_interface[.ip_interface]}]
For DS1 interfaces if_number has the syntax:
port:channel_group[.ip_interface | {.sub_interface[.ip_interface]}]
Parameters
Parameter
module
port
channel_group
sub_interface
ip_interface
if_link_type
User Level
read-write
interface console,
USB-modem, interface
Description
The interface module number
The port number of the interface
interface fastethernet,
vlan, ip address, ip admin-state,
IP interface configuration
interface serial, interface
ip broadcast-address,
Possible Default
Values Value
For E1: 0-30
For T1: 0-23
1-127
0-1024
point-to-point
Issue 1 January 2008 467