Tcp Source-Port - Avaya G450 Cli Reference Manual

To specify that rule 22 applies to all packets except for those whose destination port is 300:
G450-001(ACL 330/ip rule 22)# not tcp destination-port eq 300
Related Commands - Policy-based routing
destination-ip, dscp (policy-based routing, packet sniffing,
capture-list, source-ip,
Related Commands - Policy
composite-operation, destination-ip,
dscp-table, show isdn bri
udp source-port
Related Commands - VPN
description (ip rule), destination-ip,
icmp, ip crypto-list, ip-protocol,
show ip crypto-list,

tcp source-port

Use the tcp source-port command to define a source port with the TCP protocol for which
to apply the current rule.
Use the no form of the command to set the TCP source port to
the protocol is set to TCP and the destination port is set to its default value.
Use the not form of the command to specify that the rule applies to all TCP ports other than the
requested ports. If the protocol is not TCP, the protocol is set to TCP and the destination port is
set to its default value.
Note:
Issuing this command also sets the protocol to be TCP, if it is not already.
Note:
Syntax
[not] tcp source-port any | {{eq | lt | gt} {port_name | port_number}}
| {range start_port end_port}
no tcp source-port
tcp source-port, udp
dscp
link, source-ip,
dscp (policy-based routing, packet sniffing,
ip-rule (VPN), local-address,
tcp source-port, udp destination-port,
VPN), icmp, ip-protocol,
destination-port, udp source-port
(policy), icmp, show
tcp established, tcp source-port,
protect crypto
udp source-port
Policy - QoS lists
show ip
composite-operation,
udp destination-port,
VPN), fragment,
map, source-ip,
. If the protocol is not TCP,
any
Issue 1 January 2008
show
745