Avaya G450 Cli Reference Manual page 656

CLI Commands
Note:
The icmp command also sets the IP protocol to ICMP.
Note:
Syntax
[not] icmp {name | {icmp_type icmp_code}}
no icmp
Parameters
Parameter
name
icmp_type
icmp_code
User Level
read-write
Context
ip capture-list/ip-rule, ip access-control-list/ip-rule, ip pbr-list/ip-rule, ip qos-list/ip-rule, ip
crypto-list ip-rule
Note:
The not form of the command is not relevant in the crypto-list ip-rule context.
Note:
Example
To specify that rule 27 applies to ICMP error-reply packets:
G450-001(ACL 333/ip rule 27)# icmp Echo-Reply
To specify that rule 33 applies to any ICMP packet type except type 1 code 2:
G450-001(ACL 333/ip rule 33)# not icmp 1 2
Related Commands - Policy-based routing
destination-ip,
capture-list, source-ip,
source-port
656 Avaya G450 CLI Reference
Description
Specify that the rule
applies to this ICMP name
Specify that the rule
applies to this icmp type
Specify that the rule
applies to this icmp code
dscp (policy-based routing, packet sniffing,
tcp destination-port,
Possible Values
For an ip-rule: 0-256
For a QoS rule: 0-65535
For an ip-rule: 0-256
For a QoS rule: 0-65535
VPN), ip-protocol,
tcp source-port, udp destination-port,
Packet sniffing
Default
Value
show ip
udp