Ip Dhcp Client Client-Id - Avaya G450 Cli Reference Manual

Note:
You cannot configure both ip address dhcp and keepalive-track (object
Note:
tracking) on the WAN FastEthernet interface.
You cannot configure both ip address dhcp and keepalive-icmp
(extended keepalive) on the WAN FastEthernet interface.
You cannot configure both ip address dhcp and ip address negotiated
(PPP/IPCP address negotiation) on the WAN FastEthernet interface.
Note:
You can run ip address dhcp as many times as desired to re-initiate DHCP
Note:
address negotiation. Whenever you change the value of a DHCP client
parameter (such as client-id, client hostname), run ip address dhcp again to
re-initiate DHCP address negotiation using the new values.
Syntax
[no] ip address dhcp
User Level
read-write
Context
interface:FastEthernet (L2-L3)
Example
To enable IP address negotiation via DHCP:
G450-001(config-if:FastEthernet 10/2)#ip address dhcp
Related Commands
clear ip dhcp-client
lease, ip dhcp client
dhcp-client, show ip dhcp-client statistics

ip dhcp client client-id

Use the ip dhcp client client-id command to specify the client-identifier for the DHCP
client. Use the no form of this command to restore the default value, which is the MAC address
of the interface.
Note:
To obtain the MAC address of the interface, use the show system command or
Note:
the show interfaces fastethernet 10/2 command.
statistics, ip dhcp client
request, ip dhcp client route
client-id, ip dhcp client
track, release dhcp,
DHCP client
hostname, ip dhcp client
renew dhcp, show ip
Issue 1 January 2008 281