Dhcp And Bootp Relay; Ip Bootp-Dhcp Network - Avaya G450 Cli Reference Manual

Related Commands
set utilization cpu,
recovery, show
utilization, show voltages

DHCP and BOOTP relay

ip bootp-dhcp network

Use the ip bootp-dhcp network command to select the network from which the BOOTP/
DHCP server should allocate an address. This command is required only when there are
multiple IP interfaces over the VLAN. Use the no form of this command to remove the specified
network.
Note:
More than one network can be configured. For requests to servers, all configured
Note:
networks are used. The networks are used on a round-robin basis.
Syntax
ip bootp-dhcp network ip_net
no ip bootp-dhcp network [ip_net]
Parameters
Parameter
ip_net
User Level
read-write
Context
interface:FastEthernet (L2, L2-L3), VLAN (L2, L2-L3)
show faults, show mg
restart-log, show download,
Description
The IP subnet
list_config, show mgc,
show system, show
DHCP and BOOTP relay
show mm, show module,
temp, show timeout,
Possible Default
Values Value
Issue 1 January 2008
show
show
273