ip policy-list-copy
User level: supervisor
Use the ip policy-list-copy to copy an existing policy list to a new destination.
Syntax:
The syntax for this command is:
ip policy-list-copy <source-list> <destination-list>
Syntax
<source-list>
<destination-list>
Example:
To copy a policy list:
W310-1(super)# ip policy-list-copy 400 401
Done!
W310-1(super)#
ip-protocol
User level: privileged, supervisor.
Command Mode: IP Rule Table
Use the ip-protocol command to set the IP protocol for the current rule. This specifies
that the current rule applies to all packets having the specified IP protocol.
Use the not form of this command to specify that the current rule applies to all packets except
those having the specified IP protocol.
Avaya W310 Command Reference Guide
Description
Source list number to copy.
•
For access control lists: 300 - 399
•
For QoS lists: 400 - 499
List number to which you want to copy the original policy list.
•
For access control lists: 301 - 399
•
For QoS lists: 401 - 499
Chapter 10
W310 Policy Commands
199