Link Failover Timeout - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
link failover timeout
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
link failover timeout failTime
no link failover timeout
Command introduced before JunosE Release 7.1.0.
Specifies the time that the router waits for a port on a GE I/O module to become active
before the router switches to the redundant port. The no version restores the default
setting, in which the router sets this time automatically.
failTime—Time that the router waits; in the range 100–10000 ms
Interface Configuration
Chapter 12: L Commands
1219
Advertisement
Table of Contents
