Snmp-Agent Trap Enable Bfd - H3C S3610 Series Command Manual

Command Manual – BFD-GR
H3C S3610&S5510 Series Ethernet Switches
Parameters
None
Description
Use the reset bfd session statistics command to clear the BFD session statistics of
the current protocol.
Examples
# Clear statistics about all the BFD sessions of the current protocol.
<Sysname> reset bfd session statistics

1.1.12 snmp-agent trap enable bfd

Syntax
snmp-agent trap enable bfd
undo snmp-agent trap enable bfd
Parameters
None
View
System view
Description
Use the snmp-agent trap enable bfd command to enable sending BFD traps.
Use the undo snmp-agent trap enable bfd command to disable sending BFD traps.
By default, sending BFD traps is enabled.
Examples
Currently, the switches do not support this command.
Chapter 1 BFD Configuration Commands
1-11