Table of Contents
Advertisement
20.1.3
Flash Memory MAT Configuration
This LSI's flash memory consists of the 256-kbyte user MAT and 8-kbyte user boot MAT.
The start address is allocated to the same address in the user MAT and user boot MAT. Therefore,
when the program execution or data access is performed between two MATs, the MAT must be
switched by using FMATS.
The user MAT or user boot MAT can be read in all modes. However, the user boot MAT can be
programmed only in boot mode and programmer mode.
<User MAT>
<User Boot MAT>
Address H'000000
Address H'000000
8 kbytes
Address H'001FFF
256 kbytes
Address H'03FFFF
Figure 20.3 Flash Memory Configuration
The size of the user MAT is different from that of the user boot MAT. An address which exceeds
the size of the 8-kbyte user boot MAT should not be accessed. If the attempt is made, an undefined
value will be read.
Rev. 1.00, 09/03, page 529 of 704
Advertisement
Table of Contents
