Starting And Configuring Traversepro - Leica FlexLine TS02 User Manual

TraversePRO
options
9.14.2
Access
Applications
• It is also possible to observe sideshots and check points during the traverse,
however, check points are not included in the traverse adjustment.
• At the end of the traverse, results are displayed and an adjustment may be
calculated if desired.

Starting and Configuring TraversePRO

1. Select Prog from the MAIN MENU.
2. Select Traverse from the PROGRAMS menu.
3. Complete application pre-settings.
• Set Job:
Only one traverse per job is allowed. If an adjusted or finished traverse is
already part of the selected job, then select another job. Refer to "8
Applications - Getting Started".
• Set Tolerances:
Use Tol.: YES to activate the use of tolerances.
Enter limits for horizontal direction (the difference between measured and
calculated azimuth to the closing point), distance (the distance between
known and measured closing point), and for differences in Easting, Northing
and Height. If the adjustment results, or the deviation for a check point,
exceed these limits a warning message appears.
Press OK to save the limits and return to the Pre-settings screen.
4. Select Start to begin the application.
FlexLine, 201