Avaya S8700 Maintenance Manual page 1816

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance-Object Repair Procedures

Table 8-449. Test #6 NPE Crosstalk Test — Continued

Description / Recommendation

Test disabled via administration. This only applies to analog stations. The

default for this field is y, so you may want to determine why it has been turned

off on this station.

1. To enable the test for the particular analog station being tested, enter the

Response to the test request was not received within the allowable time period.

1. Retry the command at 1-minute intervals up to 5 times.

The test did not run due to an already existing error on the specific port or a

more general circuit pack error.

1. Examine Error Log for existing errors against this port or the circuit pack

System resources required to run this test are not available. This could be due

to a failure to seize the port.

1. Retry the command at 1-minute intervals up to 5 times.

This test can fail due to on-board or off-board problems. Off-board problems of

concern include EXP-PN and EXP-INTF faults, TDM-BUS faults, and faults

associated with the tone detectors/tone generators. Clear every off-board

problem before replacing the board. Keep in mind that a TDM-BUS problem is

usually the result of a faulty board connected to the backplane or bent pins on

the backplane.

1. Resolve any EXP-PN and/or EXP-INTF errors.

2. Resolve any TDM-BUS errors.

3. Resolve any TONE-BD and/or TONE-PT errors.

4. Test the board when the faults from steps 1, 2, and 3 are cleared. Replace

Issue 1 May 2002

change station extension command and change the

'Station' form from 'n' to 'y.'

and attempt to diagnose the already existing error.

the board only if the test fails.

field on the

Continued on next page

Troubleshooting