Avaya S8700 Maintenance Manual page 622

Maintenance Commands
Output
Separate columns identify each Packet Interface circuit pack slot. Service state is
displayed for both active and standby packet-interface circuit packs. A cabinet
number must be specified. If there are no IPSIs in the cabinet, this error message
is displayed: No IPSI in cabinet specified. Locate using list ipserver-interface.
The following display shows a typical result when status packet-interface is
entered.
status packet-interface 1
Service State:
Total Links:
Active Links:
Failed Links:
Command:
Field Descriptions
The packet-interface cabinet, carrier and circuit pack position number.
Location
One of the following states is displayed: "in-service", "out-of-service" or
Service
"uninstalled". The "standby" state is used in place of "in-service" for standby
State
packet-interface circuit packs.
The total number of links.
Total Links
The number of links that are in use.
Active
Links
The number of links that failed to be established. These links are in a recovery
Failed
state and not active. The failures can arise from problems in the packet-interface,
Links
EI or center stage hardware. The number of failed links is the number of total
links minus the number of active links.
7-366 Issue 1 May 2002
PACKET INTERFACE STATUS
Location: 01A
in-service
81
81
0
555-233-143