Renault Laguna III Manual page 2171

Rear brake pads: Removal - Refitting
a Push the piston fully into its housing using the (Fre.
1190-01) part number 77 11 223 715.
a Fit the inner pad fitted with a retaining spring (2) . It
is essential to engage the spring on the calliper pis-
ton.
a Refit the outer plate onto the calliper mounting.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the calliper onto its mounting,
REAR AXLE COMPONENTS
18617-1
- the lower guide pin bolt,
- the upper guide pin bolt.
a Torque tighten the guide pin bolts (32 Nm).
18931
a Fit the retaining spring into the base of the brake cal-
liper.
a Fit the retaining spring in place at the top of the
brake calliper using a flat-blade screwdriver.
a Refit:
- the plugs at the end of the guide pins,
- the parking brake cables onto the callipers.
ELECTRONIC PARKING BRAKE
a With the ignition on, release the electronic parking
brake:
- pull the handle,
- press the button.
The parking brake system can be heard locking, the
play compensation is set automatically.
a Check that the brake cables are correctly fitted in
their housing.
a With the parking brake released, pull on the end of
the cable; there must be a residual play of 1 to 2
mm.
33A-4
33A
18618