Renault Laguna III Manual page 2176

Rear brake calliper: Removal - Refitting
a Push the piston fully into its housing using the (Fre.
1190-01) part number 77 11 223 715.
a Fit the brake pads (see 33A, Rear axle compo-
nents, Rear brake pads: Removal - Refitting,
page 33A-3) .
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the calliper,
- the guide pin bolts,
- the rigid brake pipe on the calliper.
a Torque tighten:
- the guide pin bolts (32 Nm),
- the rigid brake pipe (14 Nm).
REAR AXLE COMPONENTS
18931
a Fit the retaining spring into the base of the brake cal-
liper.
a Fit the retaining spring in place at the top of the
brake calliper using a flat-blade screwdriver.
a Refit:
- the plugs at the end of the guide pins,
- the parking brake cables onto the callipers.
ELECTRONIC PARKING BRAKE
a With the ignition on, release the electronic parking
brake:
- pull the handle,
- press the button.
The parking brake system can be heard locking, the
play compensation is set automatically.
a Check that the brake cables are correctly fitted in
their housing.
a With the parking brake released, pull on the end of
the cable; there must be a residual play of 1 to 2
mm.
33A-9
33A
18618