Renault Laguna III Manual page 2143

FRONT AXLE COMPONENTS
Front hub carrier bearing: Removal - Refitting
F4R or M4R or M9R or V4Y or V9X
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove the bolts (8) from the hub carrier « hub -
bearing » assembly.
a Fit the tool (Tav. 1050-04) and the tool (Ms. 580) on
the « hub - bearing » assembly.
a Use the tool (Ms. 580) to extract the « hub -
bearing » assembly from the hub carrier.
a Remove the « hub - bearing » assembly.
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: Front brake calliper
mounting bolt (13,03,03,08).
a parts always to be replaced: Track rod end nut
(13,04,02,03).
a parts always to be replaced: Front wheel hub nut
(13,02,03,20).
a parts always to be replaced: front shock absorb-
er lower nut (13,02,04,11).
a Always replace the bolts of the « hub - bearing » as-
sembly.
a It is essential to check the surface condition of the
hub carrier before refitting the « hub - bearing » as-
sembly.
a Replace the hub carrier if it has deep scratches or
cracks.
a Clean the hub carrier surfaces in contact with the
new « hub - bearing » assembly using SURFACE
CLEANER (see Vehicle: Parts and consumables
for the repair) (04B, Consumables - Products).
WARNING
To ensure that the wheel speed sensor works
122711
properly, do not mark the sensor target on the
bearing.
141238
31A-45
31A