Renault Laguna III Manual page 2163

FRONT AXLE COMPONENTS
Front axle subframe: Removal - Refitting
- the rubber mounting bush (24) .
REFITTING
I - REFITTING PREPARATION OPERATION
a Degrease the body surfaces that make contact with
the sub-frame and cross member using SURFACE
CLEANER (see Vehicle: Parts and consumables
for the repair) (04B, Consumables - Products).
a parts always to be replaced: Track rod end nut
(13,04,02,03).
a parts always to be replaced: Front driveshaft
lower arm ball joint nut (13,02,03,19).
a parts always to be replaced: Front sub-frame
bolt (13,02,02,03).
a parts always to be replaced: Steering shaft yoke
bolt (13,04,01,07).
a parts always to be replaced: Steering shaft yoke
nut (13,04,01,08).
a parts always to be replaced: Power-assisted
steering pipe seal (13,04,04,22).
a parts always to be replaced: front shock absorb-
er lower nut (13,02,04,11).
a parts always to be replaced: Front wheel hub nut
(13,02,03,20).
a Refit:
- the attachments,
- the lower arms (see 31A, Front axle components,
Front driveshaft lower arm: Removal - Refitting,
page 31A-55) ,
- the steering box (see 36A, Steering assembly,
Steering box: Removal - Refitting, page 36A-6) ,
- the anti-roll bar (see 31A, Front axle compo-
nents, Front anti-roll bar: Removal - Refitting,
page 31A-68) .
DISCHARGE LAMPS
a Refit the headlight beam adjustment front sensor
(see Headlight beam adjustment front sensor:
Removal - Refitting) (80B, Headlights).
M9R, and 802 or 805 or 809 or 816 – V9X
a Refit the rubber mounting bush on the subframe.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the sub-frame using the component jack,
- the tie rod,
- the engine tie-bar.
a Remove the component jack.
a Observe the direction of fitting for the universal joint
cam nut and bolt.
a Fit the universal joint.
a Refit the universal joint cam nut and bolt.
a Position the universal joint cam nut and bolt.
a Lock the cam nut in its housing (on the universal
joint).
a Pretighten the universal joint bolt.
31A-65
31A
101354