Esp Off Switch Removal And Installation; Esp Off Switch Inspection - Suzuki GRAND VITARA JB416 Service Manual

ESP® OFF Switch Removal and Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove center garnish with audio unit (if equipped)
and HVAC control module referring to "Audio Unit
Removal and Installation: in Section 9C in related
manual".
3) Remove HVAC control module from center garnish,
referring to "HVAC Control Module Removal and
Installation: in Section 7A in related manual".
4) Remove ESP® OFF Switch (1) from center garnish
(2).
2
Tightening Torque Specifications
Fastening part
Yaw rate / G sensor assembly bolt
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fastener Information: in Section 0A in
related manual".
Special Tool
09956–02311
Brake pressure gauge
S5JB0E4606023
1
I6JB01460034-01
Specifications
Special Tools and Equipment
Electronic Stability Program:
Installation
Reverse removal procedure.
ESP® OFF Switch Inspection
Check for continuity between terminals at each switch
position.
If check result is not as specified, replace ESP® OFF
switch.
2
Terminal
ESP OFF switch
FREE
PUSH
Tightening torque
N⋅m kgf-m
8 0.8
SUZUKI scan tool
—
This kit includes following
items. 1. Tech 2, 2. PCMCIA
card, 3. DLC cable, 4. SAE
16/19 adapter, 5. Cigarette
cable, 6. DLC loop back
adapter, 7. Battery power
cable, 8. RS232 cable, 9.
RS232 adapter, 10. RS232
loop back connector, 11.
Storage case, 12. Power
supply / / /
/
1
1 2
Note
lb-ft
6.0
/ /
4F-52
S5JB0E4606024
I6JB01460035-02
S5JB0E4607001
S5JB0E4608001