1A-70 Engine General Information and Diagnosis:
DTC Troubleshooting
NOTE
Before this troubleshooting is performed, read the precautions for DTC troubleshooting referring to
"Precautions for DTC Troubleshooting".
Step
1
Was "Engine and Emission Control System Check"
performed?
2
MAP sensor and its circuit check
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Turn ON ignition switch.
3) Check DTC.
Is there DTC P0107 or DTC P0108?
3
MAP sensor output signal check
1) Check MAP sensor according to "Manifold Absolute
Pressure (MAP) Sensor Inspection (If Equipped) in
Section 1C".
Is it in good condition?
4
MAP sensor circuit check
1) Check MAP sensor circuit referring to Step 3 to 6 of
"DTC P0107: Manifold Absolute Pressure Circuit Low
Input" or Step 3 to 8 of "DTC P0108: Manifold Absolute
Pressure Circuit High Input".
Is circuit in good condition?
5
Air intake system check
1) Check air intake system for clog or leak.
Is it in good condition?
DTC P0107: Manifold Absolute Pressure Circuit Low Input
Wiring Diagram
Refer to "DTC P0106: Manifold Absolute Pressure Range / Performance".
DTC Detecting Condition and Trouble Area
DTC detecting condition
Manifold absolute pressure sensor output voltage is lower
than specified value for specified time.
(1 driving cycle detection logic)
DTC Confirmation Procedure
1) Connect scan tool to DLC with ignition switch turned OFF.
2) Turn ON ignition switch and clear DTC using scan tool and warm up engine completely.
3) Run engine at idle speed for 1 min.
4) Check DTC and pending DTC.
Action
Yes
Go to Step 2.
Go to applicable DTC
diag. flow.
Go to Step 4.
Go to Step 5.
Substitute a known-
good ECM and recheck.
Trouble area
• Manifold absolute pressure sensor circuit
• Manifold absolute pressure sensor
• A/C refrigerant pressure sensor (if equipped with A/C)
• ECM
No
Go to "Engine and
Emission Control
System Check".
Go to Step 3.
Faulty MAP sensor.
Repair or replace.
Repair or replace.
S7RW0A1104023
Need help?
Do you have a question about the SX4 and is the answer not in the manual?
Questions and answers
Adjust throttle motor
The idle speed on a Suzuki SX4 should be controlled by the Idle Air Control Valve (IACV) rather than adjusting the idle screw on the throttle body, as the screw is factory set. Before using compressed air in the idle-air-bypass passages, the IACV should be removed to prevent damage to its delicate mechanism. If there is an issue with idle speed, checking the IACV function and referring to the SX4 service manual is recommended.
This answer is automatically generated