Suzuki SX4 Service Manual page 34

0B-3 Maintenance and Lubrication:
Severe
condition code
– B C D – – – – Accessory drive belt
A – C D E F – H Engine oil and oil filter
– – C – – – – – Air cleaner filter *1
A B C – E F – H Spark plugs
– B C D – – – H Wheel bearings
Drive shaft boots / Propeller shaft
– B – D E – – H
(4WD)
Manual transaxle oil
– B – – E – – H Transfer oil (4WD)
Differential oil (4WD)
– B – – E – – H Automatic transaxle fluid
– – C D – – – – HVAC air filter (if equipped) *2
NOTE
• "I": Inspect and correct or replace if necessary
• "R": Replace or change
• *1: Inspect or replace more frequently if the vehicle is used under dusty conditions.
• *2: Clean or replace more frequently if the air from the air conditioning decreases.
Accessory Drive Belt Inspection
WARNING
!
All inspection and replacement are to be
performed with ENGINE NOT RUNNING.
Water Pump and Generator Drive Belt
Inspect belt for cracks, cuts, deformation, wear and
cleanliness. If any defect exists, replace.
Check belt for tension referring to "Water Pump /
Generator Drive Belt Tension Inspection and Adjustment
in Section 1J".
Maintenance
Nickel plug
Iridium plug
(Highly recommended)
Repair Instructions
S7RW0A0206001
Maintenance
operation
Every 15,000 km
I
(9,000 miles) or 12 months
Every 45,000 km
R
(27,000 miles) or 36 months
Every 7,500 km
R
(4,500 miles) or 6 months
Every 2,500 km
I
(1,500 miles)
Every 30,000 km
R
(18,000 miles) or 24 months
Every 10,000 km (6,000 miles) or 8
months
R
Every 30,000 km (18,000 miles) or
24 months
Every 15,000 km
I
(9,000 miles) or 12 months
Every 15,000 km
/ I
(9,000 miles) or 12 months
First time only:
15,000 km (9,000 miles) or 12
months
/ / R Second time and after:
Every 30,000 km (18,000 miles) or
24 months reckoning from 0 km (0
mile) or 0 month
R Every 30,000 km (18,000 miles) or
24 months
Every 15,000 km (9,000 miles) or
I
12 months
Every 45,000 km (27,000 miles) or
R
36 months
A/C Compressor Drive Belt (If Equipped)
Inspect belt for cracks, cuts, deformation, wear and
cleanliness. If any defect exists, replace.
Check belt for tension referring to "Compressor Drive
Belt Inspection and Adjustment: Manual Type in Section
7B" or "Compressor Drive Belt Inspection and
Adjustment: Automatic Type in Section 7B".
Maintenance interval