Dtc P0962 Pressure Control Solenoid "A" Control Circuit Low - Suzuki Grand Vitara Manual

Table for detecting condition
TCM output gear position
Actual gear position Stuck OFF (DTC P0756)
Stuck ON (DTC P0757)
DTC Confirmation Procedure
WARNING
!
• When performing a road test, select a place where there is no traffic or possibility of a traffic
accident and be very careful during testing to avoid occurrence of an accident.
• Road test should be carried out with 2 persons, a driver and tester, on a level road.
1) Connect scan tool to DLC with ignition switch OFF.
2) Clear DTCs in TCM and ECM memories by using scan tool.
3) Start engine and warm it up to normal operating temperature.
4) Shift select lever to "N" and "D" range for each 10 seconds.
5) Start vehicle and increase vehicle speed to 65 km/h (40 mile/h) with throttle position 10% or more.
6) Stop vehicle and turn ignition switch OFF.
7) Repeat Step 3) to 5) one time.
8) Stop vehicle.
9) Check DTC, pending DTC and freeze-frame data.
DTC Troubleshooting
Step
1 Was "A/T System Check" performed?
2 Check shift solenoid valve–B for operation referring to
"Solenoid Valves (Shift Solenoid-A, Shift Solenoid-B, TCC
Pressure Control Solenoid and Pressure Control Solenoid
Inspection: ".
Are they in good condition?

DTC P0962 Pressure Control Solenoid "A" Control Circuit Low

Wiring Diagram
1. Pressure control solenoid valve
www.CarGarage.ir
2nd *3
Action
12V
E92-4 YEL/RED
BRN/RED
E92-2
E92
6 5 4 3 2 1
16 15 14 13 12 11
10 9 8 7
24 23 22 21 20 19 18 17
2. TCM
www.CarGarage.ir
Automatic Transmission/Transaxle:
1st 2nd
1st 1st *1
2nd
Yes
Go to Step 2.
Clean fluid passage or
replace valve body
assembly.
2
1
E93
6 5 4 3 2 1
17 16 15 14 13 12 11 10 9 8 7
21 20 19 18
26 25
24 23 22
3. Terminal arrangement of TCM connector (viewed from harness side)
3rd 4th
4th *2 4th
3rd 3rd *4
No
Go to "A/T System
Check: ".
Replace shift solenoid
valve–B.
S5JB0A5104039
3
I5JB0A510024-01
5A-57